2-Burners Gas Cooktop 12in Eascookchef Stainless Steel NG/LPG Convertible
Eascookchef Stainless Steel Gas Cooktop 12 inch
2 Burners Power: 10,500 BTU + 5,000 BTU
Fuel type: Natural Gas (NG) are preset and can be replaced with Liquefied Petroleum Gas (LPG) nozzles.
Please note that:
1) Extra LPG Nozzles included in the pageage, the natural gas pressure regulator and the gas pipe are NOT included.
2)It is recommended that gas stove be installed and tested by professionals.
Pan Support Material:Heavy-Duty Cast Iron
Control Type: Bakelite Knobs Control
Ignition Type: Electronic pulse ignition
Voltage: 110V, 3-prong plug
Cable Length: 4.5 Feet
Installation Type: Built-in
12 Inch Dual Fuel Gas Cooktop, Easy To Install
The size of the two burners is different, just put in the gas stove burner and burner cover, easy to assemble in minutes.
The gas hob should be connected to the gas-supply by a registered installer. During installation it is essential to fit an approved gas tap to isolate the supply from the hob for the convenience of any subsequent removal or servicing.
Once the hob was installed, make sure all the connections are properly sealed, use a soapy water to test, never use flame.
Installation of built-in gas cooktop
This gas cooktop is for bulit-in use only, please verify the gas cooktop is the right size for you.
Product Dimensions: 11.6" W x 20.4" L x 3.9"H
Cut out Dimensions: 10.7" Wx 18.9" L
For a correct installation, the following precautions must be followed:
a) Fixing fittings (brackets, screws) are provided to place the gas cooktop on work top, measure 0.79 to 1.58 inch in thickness.
b) In the event the gas cooktop is not installed on a built-in oven, a wooden panel must be inserted for insulation.This panel must be placed at least 0.79 inch distance from the bottom of cooktop.
c) When installing the gas cooktop on a built-in oven, the oven should be placed on two wooden strips; in the case of a joining cabinet surface, remember to leave a space of 1.78 x 22 inch at least from the back side.
12 inch Gas Cooktop with pot stand
Preset NG nozzles(extra 2 Propane nozzles)
1/2 NPT Connector and Elbow Connector with sealing rings
Mounting brackets and screws
Cut-out Template Board
Sealing strip
User Manual
